MIL-DTL-21338B
6. NOTES
(This section contains information of a general or explanatory nature that may be helpful, but
is not mandatory.)
6.1 Intended use. Retaining key washers covered by this specification are intended for use
with slotted retaining nuts in securing and locking ball and roller bearings in position on shafts
against shaft shoulders. This specification covers the requirements for MS19069 to MS19070.
6.2 Acquisition requirements. Acquisition documents should specify the following:
a.
Title, number and date of this specification.
b.
Type, class, and size of washer required (see 1.2 and 3.4).
c.
Applicable MS part number (see 3.4).
d.
Protective finish required (see 3.7).
e.
Packaging requirements (see 5.1).
6.3 Subject term (key word) listing.
Cadmium plating
Passivation
Phosphate coating
6.4 Changes from previous issue. Marginal notations are not used in this revision to identify
changes with respect to the previous issue due to the extent of the changes.
Custodian:
Preparing Activity:
Army - AT
Navy - OS
DLA - IS
Air Force - 11
DLA - IS
(Project 5310-2014-004)
Review Activity:
Army - AR, AV, GL, MI
Navy - AS, SH, YD
Air Force - 84, 99
NOTE: The activities listed above were interested in this document as of the date of document.
Since organizations and responsibilities can change, you should verify the currency of the
information above using the ASSIST Online database at https://assist.dla.mil.
5
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business